![]() ![]() Now that you have your audio interface buffer settings dialed in let’s look at some other ways to cut back on latency. For more on this topic, check out Ableton’s article. If it doesn’t this is where Driver Error Compensation comes in.ĭEC allows you to tell Ableton how much the reported latency and the actual latency are off. The recorded audio should line up in time with the music. You’ll notice this when recording with the monitor set to OFF. Sometimes an audio interface will incorrectly report the driver latency in the Latency section. Anything over 10ms usually becomes audible and will cause noticeable latency. ![]() It is good practice to aim for 10ms of latency or less if you can get it. To test this you can use the Test Tone section in the Ableton preferences. You’ll want to set the Buffer Size to the lowest size you can without distortion or artifacts. The smaller the buffer, the less audio that is processed and the shorter it takes. The bigger the buffer block, the more audio that is processed and the longer it takes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |